© 2004 Directed Electronics, Inc. Vista, CA
2277
■
DDoooorr iinnppuutt ddooeess nnoott rreessppoonndd wwiitthh tthhee pprrooggrreessssiivvee ttrriiggggeerr,, bbuutt wwiitthh iimmmmeeddiiaattee ffuullll aallaarrmm::
Does the LED indicate that the trigger was caused by the impact sensor? (See
Table of Zones
section of this
guide.) The impact sensor, if set to extreme sensitivity, may be detecting the door unlatching before the door
switch sends its signal. Reducing the sensitivity can solve this problem.
■
TThhee VVaalleett®®//PPrrooggrraamm sswwiittcchh ddooeess nnoott wwoorrkk::
Is it plugged into the correct socket? (See
Plug-In LED and Valet/Program Switch
section of this guide.)
■
TThhee LLEEDD ssyysstteemm ssttaattuuss iinnddiiccaattoorr ddooeess nnoott wwoorrkk::
You've probably guessed already, but here goes: is it plugged in? Is the LED plugged into the correct socket?
(See
Plug-In LED and Valet/Program Switch
section of this guide.)
■
SSttaarrtteerr iinntteerrrruupptt ddooeess nnoott wwoorrkk::
Is the correct wire being interrupted? If the vehicle starts when the starter interrupt is completely disconnected,
the wrong wire has been cut.
Is the yellow H1/9 ignition wire connected to true ignition? This wire must be powered in the run and start
positions in order to work properly.
To Next Page
Loading...
Need help?
General
