Directed Electronics Viper 5501 - Timer Mode Operation

23
© 2008 Directed Electronics. All rights reserved.
Timer mode
Command : Press two-times and then .
Feedback  3MALLTIMERICONDISPLAYSANDTIMERSTARTONDISPLAYSINTHETEXT
area. The parking lights flash 4 times fast to confirm.
Notes : Enables or disables the remote start timer mode.
The system must be locked for the timer mode to operate. The system will start
EVERYHOURSFORAMAXIMUMOFSIXCYCLESUNTILCANCELEDBYTHEBRAKEHOOD
or neutral safety shut-down wires. The remote will respond with the Start and
3TOPREMOTESTARTNOTIlCATIONDURINGEACH3TARTAND3TOPOFTHE6EHICLEWHILEIN
Timer mode.
To activate timer mode with a manual transmission:
Enter the MTS mode.1.
%XITTHEVEHICLELOCKTHEDOORSWITHTHEREMOTE2.
Enter the timer mode. The parking lights quickly flash 4 times to confirm 3.
ENTRYINTOTIMERMODEVEHICLEDOESNOTREMOTESTARTATTHISPOINT6EHICLE
begins the timer mode sequence.
To exit timer mode with transmitter:
Press s twice and then press . Parking lights flash slowly four times
CONlRMINGTIMEMODEISEXITED
To exit timer mode without transmitter:
Make sure the remote start system is not operating the engine.1.
4URNTHEIGNITIONON4IMER-ODEISEXITEDANDTHEPARKINGLIGHTSmASH2.
slowly four times.
4IMER-ODEISEXITEDAUTOMATICALLYAFTERTHESIXTHRUNCYCLE4HEPARKINGLIGHTS
SLOWLYmASHTIMESWHENEXITINGTIMERMODE
Note: 4HE"ITWRITERCANCHANGETHEAMOUNTOFTIMESTHEREMOTESTARTACTIVATES
and, it can change the intervals between activations in timer mode.