Directed Electronics VIPER 5701

© 2008 Directed Electronics—all rights reserved
28
the error beep once, and then the Remote Start and Function indicator
lights will blink.
Points to remember
If the hood is open or is the brake pedal is pressed, the vehicle will
not start using remote start. The remote starter shuts down:
When the brake pedal is pressed
The hood is opened
If the alarm is triggered when armed.
When the Remote Start command is sent again from a remote
control
Runtime Check
To check the amount of runtime remaining:
After the vehicle is remote started, press the button three-times
and then hold until the remote beeps, and then release. The LEDs light
up to indicate how much time is remaining.
25% runtime remaining
100% runtime remaining
75% runtime remaining
50% runtime remaining
When the remote
start and Function
LEDs are blinking,
there is less than
three minutes of
runtime left.
A U X
▀
▀
▀
▀