To Next Page

To Previous Page

Manual unlocking

Press and hold the button until the LED on the remote ﬂashes red. The park-

ing lights will ﬂash twice to conﬁrm the doors have been unlocked.

Manual locking

Press and release the button for 1 second. The LED on the remote will ﬂash

red indicating that the command is being sent, and the parking lights will ﬂash

once to conﬁrm the doors have been locked.

Note: When installed with certain remote starter models, the doors might not

locks when the vehicle is running by the key.

Enabling/Disabling valet mode

Valet mode can be enabled and disabled using the following procedure.

When the feature is enabled, the automatic locking/unlocking operation upon

entering the active zone will be disabled. However, manual locking/unlocking

of the vehicle is possible in valet mode, as long as the ignition is off.

Enable valet mode

Within the active zone, quickly press and release the key fob button twice,

then press and hold until the remote LED ﬂashes red to conﬁrm the system has

entered valet mode. The key fob LED will no longer ﬂash to indicate whether

you are in the active zone or not.

Disable valet mode

Within the active zone, quickly press and release the key fob button twice,

then press and hold until the remote LED ﬂashes red to conﬁrm the system has

exited valet mode. The key fob LED will ﬂash to indicate whether you are in the

active zone or not.

Directed 2102T User Manual

Questions and Answers: