Other Information
48
If your TV is connected with just coaxial cables, you must tune to Channel 3 or 4, as set with the 3/4 switch on the back of your DIRECTV Plus
DVR.
Important
If you are trying to operate a device other than the DIRECTV Plus DVR that you have programmed the remote to control, make sure
you rst slide the input switch to the corresponding device (DVD player, VCR, etc.). e indicator light for the component you’re
trying to control should light up when you press a valid key for that component. If it doesn’t, make sure the input switch is clicked into
the correct position.
A remote control indicator light starts fl ashing.
e batteries in the remote control are running low and should be replaced soon. (Note that when you replace the batteries, you may
have to reprogram your remote to control other devices.)
Fine-Tuning the Signal
If you self-installed your satellite dish antenna, you may have already used Guided Setup to fi nd the dish-pointing
coordinates, acquire and fi ne-tune the signal and run a system test. If you need to run Guided Setup again, select Settings
from the Menu, then select Guided Setup. Next, press SELECT on Satellite, then select Repeat Satellite Setup.
R16 UG Book.indb 48R16 UG Book.indb 48 10/29/07 2:51:46 PM10/29/07 2:51:46 PM
To Next Page
Loading...
