71
DIRECTV Plus
®
DVR - User Guide
Activate Your DIRECTV Service
Once all the setup processes are complete, all that’s left to do is activate your DIRECTV service. Before
you make the call, be sure to:
Tune to Channel 100 and be sure you’re picking up a satellite signal (DIRECTV channel).
Have on hand your service address, social security number and a valid major credit card.
Note your access card and receiver ID numbers (fi nd these by pressing MENU, then go to Settings and
press SELECT). en go to Setup and press SELECT. Highlight Info & Test and press SELECT.
When you’re ready, just call 1-800-DIRECTV (1-800-347-3288) and pick the programming package that’s
right for you. Easy!
In order to protect your TV screen from burn-in (a side-effect caused when a stationary image is displayed for too long), the
DIRECTV Plus DVR interface automatically goes into screen saver mode, and displays a black screen with a moving logo when
no key is pressed for 5 minutes or more while a stationary image is displayed on the TV. To dismiss the screen saver and return to
what you were doing, press any key on the remote. Burn-in may cause permanent damage to your TV and DIRECTV is not liable
for any damages that may be caused to your TV.
Important
R16 UG Book.indb 71R16 UG Book.indb 71 10/29/07 2:51:58 PM10/29/07 2:51:58 PM
To Next Page
Loading...
