DYNAMIC
11
EN
Important
Important
In some cases of mistake message, to swith off the unit keep the On/Off pushed
till the screen switches off.
If the unit and the display go off during operation it may be due to the communication
cable being disconnected or cut, the communication cable fuse having blown, the
battery cable fuse having blown, or the power cable being disconnected or cut.
F6
Function: ºF Selection
To activate this function, keep the On/Off
key pressed down until the display shows
F6, and then release the key to directly enable ºF. To return to ºC, keep the control panel
-
key pressed down with the unit switched off, at which point C
C
, will ash; when it
stops ashing, release the control panel key
+
.
To Next Page
Loading...
