ATTACHMENT REMOVAL AND STORAGE
Disconnect water supply con-
nector from water supply port by
pressing gray button and pulling.
Flip the tool/floor diverter to the
floor (upward po sition).
3.
Return tools to their storage
position on back of cleaner (see
page 5). NOTE: Upholstery
attachment can be removed
from hose to clean the inside of
the tool prior to storage.
4.
1.
Remove hose from tool door by
twisting counterclockwise to
unlock. Close tool door until it
snaps into place.
EMPTYING AND CLEANING DIRTY WATER TANK
Place the dirty water tank over a
large sink and remove dirty
water tank cap by twisting to the
left (counterclockwise) and put
into a safe place. Empty water
into sink.
3.
Dirty water tank can be rinsed
out with hot tap water to remove
any remaining debris. Wipe and
let dry thoroughly before storing
to prevent mildew from forming.
NOTE: DO not use any chemi-
cals when cleaning.
Return dirty water tank cap.
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
IMPORTANT: Your Platinum Force™ Extractor is equipped with a shut off valve within your dirty water tank. When the dirty water tank become s full, the float
(viewed from the side of the tank) will rise, shutting off the air flow through the nozzle. For best results, use smooth, stead y motion keeping the nozzle flat against
the carpeting. Tipping the cleaner and breaking the seal of the nozzle and carpeting will cause the float to rise and shut off the suction. Once the float is activat-
ed, empty the dirty water tank. If the dirty water tank does not appear full, turn the power switch off and wait for the float to settle and reset. If the float repeated-
ly shuts off the suction, empty the dirty water tank.
NOTE: You will hear a noticeable change in the pitch of the cleaner. This indicates a need to empty the dirty water tank.
2.
Remove dirty water tank by lift-
ing on the dirty water tank han-
dle and pulling tank out of base.
NOTE: Nozzle does not need to
be completely removed to empty
dirty water tank.
1.
Lift dirty water tank handle and
pull out filter to clean. Rinse
under hot water and return to
dirty water tank.
Return dirty water tank to base
of cleaner by tipping the nozzle
down into the basin and drop
into place.
5.
6.
7.
8.
Lift front base of cleaner off car-
peting with one hand.Line up the
black tabs with the grooves of
front nozzle. Lift front nozzle
upwards towards cleaner and
press under latch until it locks
into place.
4.
10
Depress dirty water tank latch (1)
and simultaneously pull dirty
water tank nozzle tab up and
away from cleaner (1a).
2.
To Next Page
Loading...
