HOW TO OPERATE cont.
9
Flip the floor/tools diverter to the
tools (downward) position.
5.
While depressing blue solution spray trigger , pull attachment in a backward
motion. Release trigger and push attachment forward in same path to
remove dirty water and solution from upholstery. For heavily soiled areas,
repeat if necessary. To rinse, remember to turn soap switch to the OFF posi-
tion and repeat process. NOTE: Make sure upholstery is thoroughly dry
before use.
7.
POWER BRUSH SOAP RESULT
ON ON ON Vacuum, pump*, brushroll and soap are turned on.Used to shampoo carpets.
ON ON OFF Vacuum, pump* and brushroll are turned on. Used to rinse carpets.
ON OFF ON Vacuum, pump* and soap are turned on. Used for cleaning through attachments.
ON OFF OFF Vacuum and pump* are turned on. Used for rinsing through attachments or dirty water pick-up
with brushroll off.
OFF ON/OFF ON/OFF No power to vacuum,pump*, brushroll or soap. For any motors to energize the power switch must be on.
*Pump will be actuated by pulling solution dispensing trigger.
ABOVE FLOOR CLEANING/ATTACHMENTS
Remove hose from its stored
position on the back of the
cleaner. Lift tool door located on
the top of the dirty water tank.
Insert end of hose into tool open-
ing and twist clockwise until it
locks into place.
2.
Put cleaner in its upright posi-
tion. T urn brush switch and
power switch to the off position.
3.
Attach water supply connector
to water supply port and press
firmly until it locks into place.
4.
1.
To shampoo upholstery, be sure
brush switch is OFF, power and
soap switches are turned ON.
NOTE: Do not oversaturate the
upholstery.
6.
HOW TO TRANSPORT CLEANER
1.
Grasp the carrying handle on
the back of cleaner to trans-
port from room to room. Do not
pick cleaner up by the clean
water reservoir handle.
Turn
off
Turn
off
Turn
on
To Next Page
Loading...
