DISCOVER D904 - Registering and call recording

3.10 Overview of audio signals
Action Audio indication
Low battery 2 rapid beeps (60 sec repeat)
Nearly out of range 2 beeps
Out of range 2 pitch tone
Back in range 4 rapid beeps
Receiver volume up/
down
1 beep
Mute on 2 pitch tone (8 sec repeat)
Mute o 1 beep
Ringer (EH device) Multi tone (2 sec repeat)
3.11 Registering a new headset to the base
You can register a new primary headset unit to your
Discover D904 base using the following procedure:
• Press and hold the ‘TEL’ button (7) on the
headset base for ve seconds to enter the
registration mode. The ‘TEL’ LED (7) will ash to
indicate it is now in registration mode.
• Press and hold the ‘mute’ button (18) on the
back of the headset for ve seconds for the
headset to enter the registration mode. The
headset LED (1) will ash twice and then
light-up during the registration mode period.
• The headset will now be registered to the
base which will take around 30 seconds. When
the registration has completed, the headset
LED and the base ‘TEL’ LED (7) will stop ashing.
3.12 Using the Discover D904 for call recording
With the D904 it is possible to connect a normal
telephone call to the USB port of your computer.
This f
eature can be used to record phone calls with
voice recording software on your PC.
headsetadvisor.com | 1-800-683-5715