On the CD-Rom that came with your headset you
will nd Vidicode demo call recording software
which can be used for this purpose.
To activate the r
ecording option hold the PC/USB
switch (8) for four seconds. Both LEDs of the
PC/USB (8) and TEL (7) buttons will light. The D904
is now ready for use with recording software. If
one of the buttons is touched again this function
will be switched off and the headset will return to
the mode of the button pressed.
4. Troubleshooting
Q. I have connected my headset base to my
telephone terminal but the headset is not
working.
A. Make sure that you have the removable battery
correctly tted in the headset and that the
battery has been properly charged.
Q. The headset is working but I cannot hear
telephone calls correctly.
A. Ensure that you have the correct wiring setting
by adjusting the switch (16) on the side of the
headset base.
Q. When the headset’s ON/OFF button (2) is
pressed, the handset lifter lifts the handset but
I cannot hear the call on the headset.
A. Ensure that the headset base is connected to
the telephone’s handset port and not the
headset port (if the telephone has one).
Health and safety instructions
Please read the following safety and operational
in-structions before using your Discover Headsets
product. Please keep these instructions for your
reference. When using this product, these basic
safety precautions and warnings should be
followed to reduce the risk of fire, electric shock,
injury to persons and damage to property.
headsetadvisor.com | 1-800-683-5715
To Next Page
Loading...
