• Install the battery into the headset if not tted.
The little line on the battery has to match the
line on the battery slot, otherwise the battery
will not t.
• The headset LED (1) will turn on for about
2 seconds then turn o. Now your headset is in
standby mode.
NOTE: The rst time you use your headset, it is
recommended that the headset is charged for a
minimum of 4 hours before use.
2.1 Connecting to a telephone or terminal with a
headset port
• Using the headset cord supplied with the
product, connect the ‘TEL’ port (15) on headset
base with the headset port on your telephone.
• Use the power adaptor supplied with the
product to connect the headset base (13) to a
power socket.
• You may need to adjust the wiring switch (16)
that is located on the side of the headset base
to nd the correct wiring for your device.
2.2 Connecting to a telephone or terminal without
a headset port
• Using the headset cord supplied with the
product, connect the ‘TEL’ port (15) on headset
base with the ‘handset’ port on your telephone.
• Connect the telephone handset cord to the
handset (14) port on the headset base.
• Use the power adaptor supplied with the
product to connect the headset base (13) to a
power socket.
• You may need to adjust the wiring switch (16)
that is located on the side of the headset base
to nd the correct wiring for your device.
headsetadvisor.com | 1-800-683-5715
To Next Page
Loading...
