Discrete Wireless MARCUS 3G GPRS - Marcus; Equipment and Tools; Recommended Tools; Recommended Supplies

6
MARCUS
®
3G Radio Module Wiring Diagrams
Figure 1.2.2 below shows the MARCUS
®
3G Radio Module with a Combo GPS/Radio
antenna.
2. Equipment and Tools
The following is a general list of tools and supplies required for installation of the MARCUS
®
3G
Radio Module.
2.1 Recommended Equipment
Digital Volt and Ohm meter (DVOM)
Screwdrivers (standard, Phillips, Torx,
Hex)
Wire Strippers / Wire cutters
Coax stripper
Pliers
Razor knife
Cordless Drill
Drill bits
Wire snake
Crimping tool
Upholster removal tool
Flash light
Standard and Metric Socket set
2.2 Recommended Supplies
Electrical tape
Double sided tape
Velcro
Silicon sealant
3 amp fuses
Ground terminals
Tie-Wraps
Grommets
Crimp connectors
Butt end connectors
Sheet metal screws
18-gauge wire