Page 6
From the
Point Dish screen, run Check Switch.When the Check Switch procedure finishes, you
should see an
Installation Summary screen similar to the one shown below. Make sure the summary
screen shows reception from the 119°W and 110°W satellites on all available satellite tuners. Also
confirm the LNBF is correctly identified as a
DPP Twin (some early factory software on some
models may identify this LNBF as a
DP Twin. This identification is OK).
Exit the
Installation Summary screen and display the Point Dish/Signal screen. Make sure the
signal strength bar is green and locked for the 119°W and 110°W satellites.
Note: If the signal strength bar is not green and locked, toggle the transponder number up one and
then back down one.
Exit the
Point Dish/Signal screen and follow your receiver user's guide instructions for taking a
receiver software upgrade. If exiting the
Point Dish screen does not start the upgrade process as
described in the receiver user's guide, then turn off the receiver for at least 20 minutes (on most
receivers) to allow the receiver to take a software upgrade.
Run
Check Switch again and confirm reception for 129°W, as well as reception for the 119°W and
110°W satellites.
If installing an additional receiver:
• DISH Pro Plus - Connect the receiver and repeat steps 9 through 14 of this procedure.
• DISH Pro or Legacy - Connect the receiver. Turn the receiver off to take a software download
(takes about 20 minutes on most receivers). Run
Check Switch. Make sure the summary screen
shows reception from the 110°W, 119°W, and 129°W satellites. Note, on Legacy receivers, the
DP Plus Twin will be identified as SW64. This indication is OK and does not indicate a problem.
Note: If you have current
software, you might see
129°W
under
Port 3 on the Installation
Summary screen.
To Next Page
Loading...
