Transport - 40 1330 Operator’s Manual
Haul
Load
1. Start engine.
2. Pull boom control to raise digging boom, but keep it low.
3. Move trencher to rear of trailer or truck and align with ramps or center of trailer bed.
4. Pull axle lock to lock wheels together.
5. Slow engine to low throttle.
6. Move speed/direction control to LOAD slot, then slowly push to desired speed.
7. Drive unit onto trailer or truck, digging boom first, until tiedown position is reached.
8. Push boom control to lower digging boom, if space allows.
9. Turn ignition switch off.
10. Close fuel shut-off valve.
Crushing weight. If load falls or moves it could kill or crush you. Use
proper procedures and equipment or stay away.
NOTICE:
• Load and unload trailer on level ground.
• Incorrect loading can cause trailer swaying.
• Attach trailer to vehicle before loading or unloading.
• Ten to fifteen percent of total vehicle weight (equipment plus trailer) must be on tongue to help
prevent trailer sway.
IMPORTANT: Boom should be facing ramps or trailer.
NOTICE: If loading onto tilt-bed trailer, be prepared for trailer to tilt.
To Next Page
Loading...
Need help?
General
