Service - 56 1330 Operator’s Manual
Service Precautions
CMW
Service Precautions
Jump Starting Precaution
Welding Precaution
Cleaning Precaution
Incorrect procedures could result in death, injury, or property damage.
Learn to use equipment correctly.
NOTICES:
• Unless otherwise instructed, all service should be performed with engine off.
• Refer to engine manufacturer’s manual for engine maintenance instructions.
• Before servicing equipment, lower unstowed attachments to ground.
NOTICE: Improper jump starting could cause damage engine. To jump start, stop the engine of the
service vehicle before connecting jumper cables.
NOTICE: Welding can damage electronics.
• Disconnect battery at battery disconnect switch before welding to prevent damage to battery.
Do not turn off battery disconnect switch with engine running or alternator and other electronic
devices may be damaged.
• Connect welder ground clamp close to welding point and make sure no electronic components
are in the ground path.
• Always disconnect the ECU ground connection from the frame, harness connections to the ECU,
and other electronic components prior to welding on machine or attachments.
NOTICE: When cleaning equipment, do not spray electrical components with water.
To Next Page
Loading...
Need help?
General
