Backhoe - 84 RT80 Operator’s Manual
Setup
CMW
Setup
1. Move attachment speed/direction control to neutral position.
2. Move ground drive hand control and foot pedal to neutral position.
3. Switch transmission speed to low.
4. Switch ground drive hydraulic motor speed to low.
5. Lower rear attachment to 6” (150 mm) above ground.
6. Check that backfill blade is straight and lower it to ground.
7. Set engine speed to low throttle.
8. Move to backhoe operator’s station.
9. Lower stabilizers enough to lift front tires.
10. Move swing lock control to the unlock position.
11. Raise boom to release tension on stow lock.
12. Release stow lock by pushing handle forward.
13. Adjust engine speed to 1/2 to 3/4 throttle for digging.
IMPORTANT: For more information about stow lock, see page 44.
NOTICE: Engine speed affects speed of backhoe operation.
To Next Page
Loading...
