807 FILTER Cleaning the fi lter basket holder:
1. Loosen the adjus ng screw (25) in the middle of the fi lter basket holder
and pull off the fi lter basket holder (11) upwards from the rail (8).
2. Clean the fi lter basket holder with a brush.
3. Clean the fi lter basket holder with a damp cloth and then dry it.
4. Clean the rail with a damp cloth and then reinsert it into the fi lter
basket holder.
5. A er adjus ng to the desired height, secure the adjus ng screw.
6. Push apart the spout guide arms and pull the spout guide off the
spout.
7. Clean the spout guide and the spout holes with a damp cloth and then
dry them.
8. To assemble, push apart the spout guide arms and place them on the
spout. Make sure that the spout guide’s locking pins lock in place in the
spout holes.
Cleaning the bean hopper
The bean hopper (1) must be cleaned daily to remove any coff ee
oil residue, as this can have a nega ve eff ect on taste.
1. Grind the coff ee beans that remain in the grinding mechanism un l the
grinder runs idle.
2. Use gentle pressure to loosen the bean hopper lid from the le and right
lid holder (Fig. F, 20).
3. Using an appropriate tool, unscrew the locking screw (see Fig. F, 19) for
the bean hopper.
4. Push the bean hopper backwards un l it reaches the stop to detach it
from the grinder, and remove it from the grinder by li ing upwards.
5. Clean the inside and the outside of the bean hopper and the lid with a
damp cloth and then dry them.
6. Posi on the bean hopper on the bean hopper intake (17). When posi on-
ing the bean hopper intake, ensure that the posi oning pin of the bean
hopper is located in the corresponding recess in the bean hopper intake.
7. Push the bean hopper down slightly into the bean hopper intake and push
the bean hopper forwards to lock it into place on the grinder.
8. Push down the locking screw for the bean hopper and ghten it clockwise
using an appropriate tool.
21
807 | EN
To Next Page
Loading...
