DITTING 807 - Troubleshooting

Troubleshoo ng
Problem Cause Remedy
The grinder is
not grinding.
• The power plug is
not plugged into a
socket.
• The bean hopper
is not
inserted.
• The thermal
overcurrent cir-
cuit-breaker
has been
triggered.
• The electric fuse
has
tripped.
 Insert the power plug into a prop-
erly installed wall socket.
 Insert the bean hopper (see “Set-
 ng up the grinder and inser ng
the bean hopper” sec on).
 Check whether the circuit break-
er release bu on has popped
out. Push it back in if necessary.
If the circuit-breaker repeatedly
pops out, contact your supplier
(see “Maintenance and service”
sec on).
 Check the electric fuse. Return it
to its original state or replace it.
Check whether other loads are
connected to this fuse and if so,
pull their plugs. If the fuse trips
repeatedly, contact your supplier
(see “Maintenance and service”
sec on).
COMMERCIAL COFFEE GRINDER
24