20
- MODE2: VTX RF remains off (0mW) after power-up, and exits 0mW under the following conditions:
1. Aircraft is armed. 2. Exit 0mW mode through stick command. 3. Configure VTX power to non-
0mW through FC.
SHORTCUTS: Two different stick commands are provided for switching or exiting 0mW. See the Stick
Movement diagram for details.
Notes:
- HDZero VTX will still become hot even on P1mW mode. It is better to keep VTX on 0mW when it will
be idle for a while. Though the receiver will not have live video on this mode, it will come back as
soon as the aircraft is armed.
- Use sticks shortcut to enter 0mW, and to exit 0mW mode.
To Next Page
Loading...
