dji Air 2S - Gimbal and Camera Operations

DJI Air 2S User Manual
30
©
2021 DJI All Rights Reserved.
Battery Protection Mechanisms
The battery LED indicator can display battery protection indications triggered by abnormal charging
conditions.
If the battery protection mechanisms activate, in order to resume charging it is necessary to unplug
the battery from the charger and plug it in agai. If the charging temperature is abnormal, wait for the
charging temperature to return to normal, and the battery will automatically resume charging without
requiring to unplug and plug in the charger again.
Inserting the Intelligent Flight Battery
Insert the Intelligent Flight Battery into the battery compartment of the aircraft. Make sure it is mounted
securely and that the battery buckles click into place.
Click
Battery Protection Mechanisms
LED1 LED2 LED3 LED4 Blinking Pattern
Status
LED2 blinks twice per second Overcurrent detected
LED2 blinks three times per
second
Short circuit detected
LED3 blinks twice per second Overcharge detected
LED3 blinks three times per
second
Over-voltage charger detected
LED4 blinks twice per second Charging temperature is too low
LED4 blinks three times per
second
Charging temperature is too
high
Removing the Intelligent Flight Battery
Press the battery buckles on the sides of the Intelligent Flight Battery to remove it from the
compartment.
DO NOT detach the battery when the aircraft is powering on.
Make sure that the battery is mounted rmly.