dji Air 2S - Remote Controller; Remote Controller Profile; Using the Remote Controller

34
©
2021 DJI All Rights Reserved.
Remote Controller
Remote Controller Profile
Built into the remote controller are four antennas and DJI’s long-range transmission technology O3
(OcuSync 3.0), oering a maximum transmission range of 7.5 mi (12 km) and displaying video from the
aircraft to DJI Fly on a mobile device at up to 1080p. The aircraft and camera are easy to control using
the onboard buttons and the detachable control sticks make the remote controller easier to store.
In a wide-open area with no electromagnetic interference, O3 smoothly transmits video links at up to
1080p, no matter the change in ight attitude. The remote controller works at both 2.4 GHz and 5.8 GHz,
automatically selecting the best transmission channel. O3 reduces the latency to 120-130 ms by
improving the camera performance through its video decoding algorithm and the wireless link.
The built-in battery has a capacity of 5200 mAh and a maximum run time of 6 hours. The remote
controller charges the mobile device with a charging ability of 500 mA@5V. The remote controller
automatically charges Android devices. For iOS devices, first make sure that charging is enabled in
DJI Fly. Charging for iOS devices is disabled by default and needs to be enabled each time the remote
controller is powered on.
Compliance Version: The remote controller is compliant with local regulations.
Control Stick Mode: The control stick mode determines the function of each control stick movement.
Three pre-programmed modes (Mode 1, Mode 2, and Mode 3) are available and custom modes can
be congured in DJI Fly. The default mode is Mode 2.
Using the Remote Controller
Powering On/O
Press the power button once to check the current battery level. Press once, then again, and hold to
power the remote controller on or o. If the battery level is too low, recharge before use.
Controlling the Gimbal and Camera
1. Shutter/Record Button: Press once take a photo or to start or stop recording.
2. Photo/Video Toggle: Press once to switch between photo and video mode.
3. Gimbal Dial: Use to control the tilt of the gimbal.
4. Press and hold the customizable button in order to be able to use the gimbal dial to adjust the zoom
in video mode.
Charging the Battery
Use a USB-C cable to connect an AC power charger to the USB-C port of the remote controller. It
takes approximately four hours to fully charge the remote controller.
Power Outlet