dji Cendence - Slave Remote Controller Configuration; Setting Remote Controller to Slave; Searching for Master Controller

Cendence User Guide
16
©
2017 DJI All Rights Reserved.
When in Slave mode, the remote controller cannot link to the aircraft nor control aircraft
orientation.
Select Master in DJI GO 4 if you wish to connect and control the aircraft with the remote
controller.
2. Search the “Master” remote controller in the surrounding area.
3.SelecttheMasterremotecontrollerfromtheMasterlistandinputthepasswordtoconnect.
“Slave” Remote Controller:
1. Select Slave to set the remote controller to Slave.
Search Master
Remote Controller Settings
Master and Slave
Set Remote Controller Status
Master
Slave
OFF
Master ID: 28172d Slave ID: 14f93f
Connection Status:OFF
2816f2
28172d
-56.00
RSSI
-22.00
Search Master
Master
Scan
Connect
Connect
Search Master
Remote Controller Settings
Master and Slave
Set Remote Controller Status
Master
Slave
OFF
Master ID: 28172d Slave ID: 14f93f
Connection Status:OFF