dji Cendence - Using Accessories; Mounting the Patch Antenna

©
2017 DJI All Rights Reserved.
17
Make sure to power off the remote controller before removing and attaching the antennas.
Usage
The signal transmission between aircraft and remote controller perform best within the range that
displayed in the picture shown below:
Using Accessories
Using the Patch Antenna
Mounting the Patch Antenna
Follow the steps below to mount the patch antenna.
1. Rotate the original antenna screws to remove the antennas. Only pull the antennas from the
screws, not the antenna bodies, to avoid damage.
2. Connect the patch antenna with two screws, connect two antenna cables, and connect the CAN
bus cable to the remote controller.
Ensuretheaircraftisyingwithintheoptimaltransmissionrange.Adjustthedistanceandposition
between the operator and the aircraft to achieve optimal transmission performance.