8
©
2016 DJI. All Rights Reserved.
User Manual
INSPIRE RAW
Battery must be fully charged before using it for the rst time. Refer to "Charging the Intelligent
Flight Battery" (P24) for more information .
If you have purchased the dual remote controller version, you must use the Master remote
controller to deactivate Travel Mode. Refer to "Setting Up Dual Remote Controllers Mode" (P32)
section for more information about Master remote controller.
Be sure to remove the gimbal from the aircraft before switch from Landing Mode to Travel Mode.
Place the aircraft on the smooth and reective surface (e.g. table or tile) before switching between
the travel modes to the landing mode. Do not place the aircraft on the rough and sound-absorbing
surface (e.g. carpet) before switching between the travel modes and landing mode.
Installing the Gimbal and Camera
The following steps use the DJI MFT 15mm f/1.7 ASPH as illustration of how to mount the camera lens to
the camera body. Be sure to power off the battery before installation.
1. Remove the camera body cap.
2. While holding down the Lens Release Button, rotate the Lens Lock clockwise to unlock it.
3. Remove the lens cap and rear cap.
Lens Release Button
1
2
3
4. Align the two Lens Mount Indexes on the camera body and camera lens, and insert the camera lens
into the body of the camera.
5. Rotate the camera lens clockwise until you hear a click.
6. Rotate the Lens Lock counterclockwise to lock it.
7. Mount the Balancing Ring (or a lter) and the Lens Hood.
6
5
4
7
Click
Balancing Ring (or Filter)
Lens Hood
To Next Page
Loading...
Need help?
General
Weight and Dimensions
