dji INSPIRE 2 - Page 84

8
EN
10. Flight
#FGPSFUBLJOHPGGFOTVSFUIBUUIF"JSDSBGU4UBUVT#BSJOUIF%+*(0BQQ
JOEJDBUFTA3FBEZUP(P(14PSA3FBEZUP(P7JTJPOJOnZJOHJOEPPST
Ready to Go (GPS)
In the DJI GO 4 App
Auto Takeoff
The aircraft will take off and hover at
an altitude of 4 feet (1.2 meters).
Auto Landing
The aircraft will land vertically and stop its
motors.
Return-to-Home (RTH)
Brings the aircraft back to the Home
Point. Tap again to stop the procedure.
Gimbal Working Modes
Includes Tracking Mode, Free Mode and
Reset Mode.
More Intelligent Flight Modes
Tap to use TapFly (P-mode), ActiveTrack (P-mode) and more.
2. Pull left stick down (slowly)
until you touch the ground.
Hold a few seconds to stop
the motors.
6WRSPRWRUPLGÁLJKWPress the RTH
button while simultaneously pulling
the left stick to the bottom inside
DPSOFSBOEIPMEGPSTFDPOET0OMZ
TUPQNPUPSTNJEnJHIUJOFNFSHFODZ
situations when doing so can
reduce the risk of damage or injury.
Manual Takeoff
Combination Stick Command to start/stop the motors
Left stick up
(slowly) to take off
or
Aircraft Status Indicator
. . .
Ready to go (GPS working).
. . .
P-ATTI or ATTI mode.
.....
Not connected to remote controller.
. . .
Vision System on, GPS off or unavailable.
. . .
Low battery warning.
.....
Critically low battery warning.
——
Critical error.
. . .
Compass calibration required.
 8BUDIUIFUVUPSJBMJOUIF%+*(0BQQPSPOUIFPGmDJBM%+*XFCTJUFUPMFBSONPSF
Always set an appropriate RTH altitude before takeoff. Refer to the Disclaimer and Safety Guidelines for more details.
Return-to-Home (RC)
4BNFBTUIF35)CVUUPOJOUIF%+*(0BQQ#SJOHTUIFBJSDSBGU
back to the Home Point.
Press and hold to initiate the RTH procedure. Press again to cancel.
Determine RTH status by sound:
Single beep... Request to return, but not receive the respond
from the aircraft yet.
Double beep... RTH in progress.
 3PUBUJOHQSPQFMMFSTDBOCFEBOHFSPVT%0/05TUBSUUIFNPUPSTJOOBSSPXTQBDFTPS
when there are people nearby.
Always keep your hands on the remote controller so long as the motor is still spinning.
After landing, power off the aircraft before turning off the remote controller.
 5BLFPGGGSPNBnBUTVSGBDFJOBXJEFPQFOTQBDFXJUIUIFSFBSPGUIFBJSDSBGUGBDJOH
towards you.
Intelligent landing gear will automatically raise after takeoff and lower when landing.
They can also be controlled manually using the Transformation Switch.
The aircraft will not be able to land if the landing gear does not lower.
Manual Landing
1. Ensure the landing gear is lowered
before landing.
Raise Lower