dji MATRICE 600 - Page 39

©
2016 DJI All Rights Reserved.
37
MATRICE 600 User Manual
[1] System Status
: Indicates the current aircraft system status and GPS signal strength.
[2] Battery Level Indicator
: Describes the battery level of the aircraft according to its immediate status. The colored
zones represent the various stages of battery level. When the battery level drops to a certain
stage, the system will prompt the user to take the appropriate action.
[3] Flight Mode
: The text next to this icon indicates the current ight mode.
Tap this icon to congure the Main Controller Settings, to change the ight limits and set the gain
values.
[4] GPS Signal Strength
: Shows the current GPS signal strength. White bars indicate adequate GPS strength.
[5] Remote Controller Signal
: Shows the signal strength of the remote controller.
[6] HD Video Link Signal Strength
: Shows the signal strength of the HD video downlink between the aircraft and the remote
controller.
[7] Battery Level
61%
: Shows the current battery level.
Tap this icon to view the battery information menu where you can set the battery warning
thresholds and view the battery log.
[8] General Settings
: Tap this icon to view General Settings where you can set the ight parameters, and enable
the Flight Route display.
[9] Camera Operation Bar
This bar will be displayed when using a Zenmuse X3, X5 series or XT gimbal with camera.
Shutter and Recording Settings
: Tap this icon to enter various camera value settings including the Color Mode, Video Size,
and Image Size.
Shutter
: Tap this button to take a single photo. Press and hold this button to switch between Single
Shot, Triple Shot and Timed Shot modes.
Record
: Tap once to start recording video, then tap again to stop recording. You can also press the
Video Recording Button on the remote controller.
Playback
: Tap this icon to play back photos and videos after they are captured.