dji MATRICE 600 - Warning; Assembly Warning; Flight Warning

2
©
2016 DJI All Rights Reserved.
Warning
The rotating propellers can cause serious damage and injury. Fly with caution at all times.
Assembly Warning
1. Ensure that all other parts are installed before inserting the Intelligent Flight Batteries.
2. Use the extension rod to separate the GPS module from the center frame to avoid interference with
the power system.
3. Ensure the frame arms are mounted correctly.
4. DO NOT remove any glued-in screws.
5. Unless specied, screws with blue or red glue on their threads can be used without threadlocker
for the rst time. After that, apply a suitable amount of threadlocker to the thread.
6. The Matrice 600 should be lifted off the ground when testing the landing gear or recalibrating servo
travel.
Flight Warning
1. The aircraft is not waterproof. DO NOT y in rainy or snowy weather.
2. Ensure that all parts are in good condition before each ight. DO NOT y with worn or damaged
parts.
3. Ensure that the propellers and motors are installed correctly and propellers and frame arms are
unfolded before each ight.
4. Ensure that all cables are connected correctly and rmly before each ight.
5. Maintain a safe distance from people, buildings, high voltage power lines, tall trees, water, and
other hazards when ying the aircraft.
6. Only use DJI TB47S/TB48S Intelligent Flight Batteries as the power supply.
7. DO NOT overload the system.
8. DO NOT go near or touch the motors or propellers when they are spinning, as this can cause
serious injury.
9. Disconnect the batteries and remove the camera during transportation to avoid damage or injury.
10. Only use compatible DJI parts.
If you encounter any problems or if you have any questions, please contact your
local DJI authorized dealer or DJI Support.
DJI Support Website:
www.dji.com/support