dji MATRICE 600 - Installation; Mounting the Frame Arms

6
©
2016 DJI All Rights Reserved.
1. Preparing the frame arms.
a. Check for cracks on all propellers. Ensure all the screws are secured in position.
b. Ensure all motors are mounted correctly and rmly and are free from obstruction.
c. Mount the arms with red motor bases to the M1 and M2 positions (on both sides of battery
compartment No. 1) to indicate the nose direction of the Matrice 600. When viewed from above
with battery compartment No. 1 facing forward, the M1 position is on the right side of battery
compartment No. 1, and the M2 - M6 positions are arranged counter-clockwise from M1.
d. Identify the “CW” and “CCW” marks on the propellers. Mount the frame arms marked “CCW” to
the M1, M3 and M5 positions of the center frame. Mount the arms marked “CW” to the M2, M4
and M6 positions of the center frame.
M1M2
M3 M6
M4 M5
Aircraft’s Front
Motor
CW or CCW Mark
Propeller
Propeller Holder
Propeller Cover
Front / Rear Indicator
Arm Screws
Screw Holes
Arm Tube
Power Cables
ESC Signal Cable
Installation
Tools Required: 1.5 mm hex key, 2.0 mm hex key, 2.5 mm hex key, medium strength threadlocker.
Mounting the Frame Arms
The frame arm cables come with heat shrink tubing for easy wiring. Remove the tubing from
the cables just before connecting the cables.