dji MATRICE 600 - Page 43

©
2016 DJI All Rights Reserved.
41
MATRICE 600 User Manual
SDK
Enable API Control
If you are using the DJI SDK, select Enable API Control to allow the flight control system to
communicate with external devices such as an on-board computer. The external device will be able
to control the aircraft only if the Flight Mode Switch on the remote controller is toggled to F-mode. For
information on setting the API parameters, read the related documents and manuals on the DJI SDK
page of the DJI Developer website (https://developer.dji.com).
API Control and the Intelligent Flight Modes cannot be used at the same time. If you are
using Intelligent Flight Mode, nish the current intelligent ight mission and toggle the Flight
Mode Switch to F-mode again to use API Control.
API Control is automatically disabled after firmware updates. Re-enable this option if
necessary.
Ground Station Status
If Ground Station Status is enabled, the data from the ight control system to external devices will
include information on the Ground Station mission.
Battery Manager
View the battery information on this page.
Firmware Update
Check the current rmware version of the aircraft and ensure the installed rmware is up-to-date. If
not, login with your DJI account and click the Upgrade button.
Ensure that your computer has internet access, or else you cannot get the latest rmware.
Ensure that the Intelligent Flight Batteries have enough power supply.
The aircraft settings may be reset after rmware upgrade. Check the settings.
Simulator
Use the simulator for ight training according to the tips in the software.
Lightbridge 2
Firmware Update
Check the current rmware version of the Lightbridge 2 Air System and ensure the installed rmware
is up-to-date. If not, login with your DJI account and click the Upgrade button.
Ensure that your computer has internet access, or else you cannot get the latest rmware.
Ensure that the Intelligent Flight Batteries have enough power supply.
Both the Lightbridge 2 Air System and the remote controller rmware must be up-to-date, or
else they will not link.
Update the remote controller firmware via the DJI GO app. Refer to Upgrading the
Firmware (p. 54) for details.
Restart the aircraft after upgrading the aircraft and Lightbridge 2 Air System rmware.