dji Osmo Action GPS - Button Features

5
EN
Button Features
Quick Switch Button
• Press and hold: power on or off the remote controller.
• Pressonce:switchbetweenshootingmodeswhenconnectedtothecamera.
Link Button
• Pressandhold:linktheremotecontrollerandthecamera.
• Press once: power on the camera when the camera is in sleep mode and connected to
theremotecontroller.Duringthelinkingprocess,pressoncetocancellinking.
Shutter/Record Button
• Press and hold: power off the camera. When the camera is in sleep mode, press and hold
to power on the camera.
• Pressonce:takeaphotoorstart/stoprecording.Whenthecameraisinsleepmode,press
once to start SnapShot.
Note: bothbothscenariosrefertosituationswhentheremotecontrollerisconnectedtothe
camera.
Button Combinations
• Press and hold the shutter/record button and link button for four seconds: switch
betweensingle-cameracontrolmodeandmulti-cameracontrolmodeandstartlinking.
• Press and hold the quick switch button and shutter/record button for four seconds:
view the firmware version of the remote controller
• Press and hold the quick switch button and link button for four seconds: forget the
Bluetoothconnectionandstartlinking.
QuickSwitchButton
LinkButton
Shutter/Record Button