dji Osmo Action GPS - Operation; Installation Methods

7
EN
Operation
Installation Methods
Thepackageincludestwowriststrapsofdierentlengths.Theremotecontrollercanbexed
tothewristusingthelongwriststrapandcanalsobexedtothebicyclehandlebar,motorcycle
handlebar,backpackstrap,andotherlocationsusingtheshortwriststrap.
Installing the Long Wrist Strap
Fixtheremotecontrollerinasuitablepositiononthewristandfastenthehook-and-loop
fastenerproperly,asshownbelow.
Installing the Short Wrist Strap
1. Removethebucklefromtheholeofthelongwriststrap,asshownbelow.
2. Threadtheshortwriststrapthroughthestrapslotonthebackoftheremotecontroller.
Makesurethatthesidewiththeraisedsurfaceisfacingupward.
3. Adjust the position of the remote controller on the wrist strap until one end of the strap slot
reachestheraisedsurface.Threadthebucklethroughtheholeontheshortwriststrap.
1
2