dji Osmo Action GPS - Screen Description

6
EN
Screen Description
Thescreendisplaysthestatusoftheconnectedcamera,thebatteryleveloftheremote
controller, and other information. When controlling multiple cameras, the screen displays the
numberofcamerasconnected.Thedisplayonthescreenvariesdependingonthecamera
mode.
1. VericationCode:displaysthevericationcode.Whenthecameraisfound,boththeremote
controllerscreenandthecamerascreenshowthesamevericationcode.TapAcceptonthe
camera screen.
2. GPS Signal: displays GPS signal strength. When the remote controller is searching for the
GPS signal, the iconwillbedisplayed.
3. BatteryLevel:displaysthebatteryleveloftheremotecontroller.
4. Connection Status: displays the connection to the camera via Bluetooth.
5. microSDCardInformation:displayseithertheremainingnumberofphotosorthevideo
durationthatcanbetakenorrecordedaccordingtothecurrentshootingmode.Theiconis
displayed only when a camera is connected.
6. ScreenInformation:thecamerainformationwillbesynchronizedwhenthecamerais
connected.
The screen will enter sleep mode if there is no operation within 3 minutes. The remote
controller will power off if there is no operation after 10 minutes when there is no camera
connectedandtheremotecontrollerisnotcharging.Whenthescreeniso,pressanybutton
toexitsleepmodeandcontinueusingtheremotecontroller.
1 2 3
4
5
6