To Next Page

To Previous Page

Mounting the Mobile Phone Vertically

1. To mount the mobile phone vertically, loosen the Holder Lock knob and rotate the mobile

phone holder 90 degrees.

3. Adjust roll axis balance by either loosening the Balance Adjustment knob and stretching

the Adjustable Arm or by adjusting the position of the mobile phone holder. The roll axis is

balanced if the mobile phone remains level when released.

Adjust the Adjustable

Arm to obtain roll

axis balance.

If the roll axis cannot be balanced

by adjusting the arm, pull the

mobile phone holder left to balance.

Left

Right

Ensure the mobile phone is properly installed in the holder and the system is balanced

before each use. Make sure the mobile phone is ush with the holder and the Balance

Adjustment knob and Holder Lock knob are tightened before use.

It is important to balance the mobile phone in order to achieve optimal performance.

The Osmo Mobile 2 should only be balanced when powered off.

2. Place the mobile phone in the mobile phone holder while pulling the sides of the holder

outwards, then release the sides of the holder so they hold the phone in place. Hold the

Osmo Mobile 2 horizontally and adjust the position of the phone (in the holder) to balance

the tilt axis. The tilt axis is balanced if the mobile phone remains level when released.

90°

Other manuals for dji OSMO MOBILE 2

Questions and Answers:

Need help?

Do you have a question about the dji OSMO MOBILE 2 and is the answer not in the manual?

General