To Next Page

To Previous Page

Using the Osmo Mobile 2

Controls and Operations

The buttons on the handle allow ne control over the gimbal and mobile phone. The gimbal

converts joystick movements into smooth pan and tilt transitions, and uses SmoothTrack

technology to reduce the impact of natural vibrations. In Follow mode the mobile phone can

also be positioned directly by hand.

1. Power/Mode Button

Press and hold the Power/Mode button for 1.5 seconds to power the Osmo Mobile 2 on/off.

With the Osmo Mobile 2 powered off, press the Power/Mode button once to check the

battery level. The current battery level will be displayed on the battery level indicators.

Hold the Osmo Mobile 2 steady and upright while it is starting up.

The Osmo Mobile 2 starts up in Follow mode each time it is powered on.

With the Osmo Mobile 2 powered on:

Press the Power/Mode button once to switch the gimbal mode. The Osmo Mobile 2

will switch to Free mode from Follow mode. In Free mode the mobile phone stays in its

current position regardless of handle movements. Press the Power/Mode button again to

return to Follow mode.

Press the Power/Mode button twice quickly to center the mobile phone.

Press the Power/Mode button three times quickly to switch between the mobile phone's

front and rear cameras.

You cannot switch between front and rear cameras while recording video.

Tracking will stop if you switch between front and rear cameras while using

ActiveTrack.

Other manuals for dji OSMO MOBILE 2

Questions and Answers:

Need help?

Do you have a question about the dji OSMO MOBILE 2 and is the answer not in the manual?

General