©
2022 DJI All Rights Reserved.
7
M Button
When powered off
Press once: check the battery level
Press and hold: power on
When powered on
Press once: switch between gimbal modes
Press three times: enter standby mode (press any button to exit)
Press and hold: power off. Press and hold for 20 seconds to force
power off
Using Osmo Mobile SE
On-board Features
Status Panel
Displays the System Status Indicator, Battery Level Indicator, and Gimbal Mode.
System Status Indicator Descriptions
Blinking Pattern Descriptions
Solid yellow Bluetooth disconnected
Solid green Bluetooth connected
Pulses yellow or green Standby mode
Blinks red and green alternately Firmware updating/firmware update failed
Solid red Abnormal status detected
Battery Level Indicator Descriptions
Blinking Pattern Battery Level
Blinks red quickly ≤5%
Solid red 6%-19%
Solid yellow 20%-60%
Solid green >60%
Gimbal Mode
Follow: pan and tilt axes follow, where both the pan and tilt axes follow the movement
of the grip. Suitable for scenarios when moving up and down or on a slant.
Tilt Locked: only the pan axis follows, where only the pan axis follows the movement
of the grip. Suitable for scenarios such as arc shots or moving from left to right.
FPV: pan, tilt, and roll axes follow, where all three axes follow the movement of the
grip. Suitable for shooting the first-person view.
SpinShot: pan, tilt, and roll axes follow. The joystick can be used to control the roll axis
rotation. SpinShot enables footage to be shot while rotating the camera 360°. This is
suitable for shooting push, pull, and down.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
