Ronin-S
User Manual
©
2019 DJI OSMO All Rights Reserved.
27
Joystick
The joystick is already set to default: push the joystick up or down to control the
movement of the tilt axis, and push it left or right to control the movement of the pan axis.
Go to the Control page to adjust the parameters for the pan, tilt and roll axes.
Camera Control Button
1. Press halfway to auto focus, as you would for the shutter button on most DSLR
cameras.
2. Press once to start/stop recording.
3. Press and hold to take a photo.
Focus Wheel
The Focus Wheel is used for controlling camera focus. When a compatible camera
system connects to the Ronin-S, you can pull focus via the included cable.
Button Functions
1. Focus Wheel
Rotate to control camera focus.
2. CAN/S-Bus Switch
Switch to the corresponding connected receiver.
CAN: switch to the CAN position when connected to the DJI Pro Wireless Receiver.
S-Bus: switch to the S-Bus position when connected to a third-party remote-control
system (e.g. Futaba).
3. Multifunction Button
One click: a-b-point calibration (when connected to an external focus motor).
Double click: a double-click will perform a travel calibration when connected to an
external focus motor.
Click and hold on: flips the control direction.
4. Status Indicator
Shows the focus wheel’s current working status.
Single red blinking: disconnected.
Double red blinking: the module requires a firmware update.
1 2 3 4 5 6
To Next Page
Loading...
