Ronin-S
User Manual
26
©
2019 DJI OSMO All Rights Reserved.
Button Functions
Power Button
1. Press and hold to power on the gimbal.
2. Press once/twice to pause the gimbal’s motors, and press once/twice again to
unpause.
M Button
1. Press once to switch the user profiles.
2. Press and hold to enter Sport mode.
3. Press twice to enter/exit Portrait mode.
4. Press three times to enter/exit 3D Roll 360.
5. Press six times to restore the default Bluetooth password. The profile light glows to
indicate the password has been restored successfully.
Trigger
1. Press and hold to enter Lock mode.
2. Press twice to re-center the gimbal.
3. Press three times to turn the gimbal 180° so that the camera faces you.
4. Press four times and hold to begin Joystick Calibration.
Joystick calibration is only required if the gimbal drifts (if the gimbal moves by itself
without input from the joystick). During calibration, push and pull the joystick several
times as far as it will go in all directions. Press four times and hold the trigger again to
complete calibration.
The calibration has failed if the LEDs blink red. If they do try to go through the
calibration process again.
5. Press and hold Ronin-S’ M button and trigger simultaneously for four seconds to start
Auto Tune. The default Auto Tune grade is Medium.
To Next Page
