Ronin-S
User Manual
©
2019 DJI OSMO All Rights Reserved.
25
Motion
You can set the joystick control by adjusting deadband, max speed, smoothing, and
endpoints for each axis. There are three default profiles for each settings.
Deadband: When the deadband value increases, more stick movement will be required to
translate into the actual movement of the gimbal.
Max Speed: Allows the remote-controlled rotational speed to be adjusted.
Smoothing: Allows you to control the sensitivity of the gimbal. The lower the smoothing
value, the more sensitive the movement of the gimbal.
Endpoint: Limits the rotational range of the gimbal by setting the endpoints. The pan axis
has a slip-ring, enabling Ronin-S to rotate continuously when the endpoints are set to
180°. On the tilt axis, you can set up the endpoints according to your requirements. Some
longer lenses may hit the gimbal frame. Set the endpoint angle to prevent such cases.
Status
Settings
Motor Pause: Tap to enable motor pause and the motor will power off.
Disable Selfie Mode: Tap to disable Selfie mode to prevent accidentally entering selfie
mode and interrupting recording.
System Calibration: Use only if you notice drift on any of the axes. Tap and then select
Calibrate System. Make sure the calibration is complete before picking up Ronin-S.
Advanced Calibration: use Advanced Calibration when the roll axis is drifting.
Restore Gimbal Setup: Tap to restore the motor parameters of the gimbal, Follow mode,
and control settings to default.
Checklist
When the gimbal status is abnormal, the status information is displayed here.
To Next Page
Loading...
