dji Ronin-S - Customizing User Profiles and Motion

Ronin-S
User Manual
24
©
2019 DJI OSMO All Rights Reserved.
Gimbal Follow Mode
Pan and Tilt Follow: Pan and tilt axes follow the movement of the grip.
Pan Follow: Only pan axis follows the movement of the grip.
FPV: Pan, tilt and roll axes follow the movement of the grip. Speed must be set to Medium,
High or Customized. FPV mode is not available when the speed is set to Low. When the
speed is set to customized, the pan speed value must be set to 50 or higher. Note that
Deadband is unavailable in FPV mode.
Custom: Tap the blue arrows of the figure to manually set which axis will follow the
movement of the grip.
3D Roll 360: Allows the camera to rotate 360° at any attitude.
Speed: Determines how fast the camera travels while translating a pan, tilt, or roll
movement.
Deadband: The deadband determines how much movement the gimbal tolerates prior to
translating the pan, tilt, and roll movement of the camera.
Push: After enabling Push, the gimbal axis can be manually pushed to the desired
position.
Control Settings
Channels
The channel indicator provides feedback when configuring remote operation. Pan, tilt,
and roll channels can be reassigned and each axis can also be inverted. Normal means
the direction of movement is the same as the joystick. Inverted means the direction of
movement is the opposite of the joystick.
When using the joystick, you can only control CH1 and CH3, which is mapped to tilt and
pan axes by default. You can customize channel mapping by tapping on the name of the
axis on the right of the screen.
UserProle
Three user profiles can be set and save.