dji Ronin-S - Page 25

Ronin-S
User Manual
©
2019 DJI OSMO All Rights Reserved.
23
a particular axis constantly goes beyond that range, you will need to check your unit’s
mechanical balance.
Ensure the Ronin-S is placed on a steady platform, and working in Upright
mode and centered when using Auto Tune.
If mounting the Ronin-S on a car, it is recommended to adjust the Stiffness value
manually after Auto Tune is complete. Manually tune the Stiffness as high as possible
until you feel the gimbal start to vibrate. Then back down the Stiffness values.
Be sure the gimbal is balanced and Stiffness values are tuned properly every
time you change the camera or lens.
By tapping the Advanced Settings toggle, you will be able to see Strength, Filter and
Control tabs. We recommend leaving these three parameters as default for most cases.
Users can still adjust them with proper experience.
Strength: It is recommended to leave this setting as default. The motor strength
adjustment allows you to minimize Ronin-S’ attitude error. This parameter affects how
quickly the Ronin-S will react to changes in orientation. If you see any unusual attitude
errors, you may minimize it by increasing the corresponding motor’s strength. However,
increasing strength too much may also cause the Ronin-S to over adjust its orientation
and induce shake. When the Strength value is set to 10, and the pan axis cannot stop
immediately after a fast rotation, try to decrease the value to 6.
Filter: This setting can ease high-frequency vibrations of the Ronin-S. When the Ronin-S is
vibrating at a high frequency, you may experience numbness while touching the gimbal
motors of each axis. In such instances, it is recommended to lower the Filter settings.
Control: It is recommended to leave this setting as default. Control can guide the Ronin-S
to better handle low-frequency vibrations. If your Ronin-S vibrates at a visible range, you
can suppress it by increasing Control. When the vibration persists at low frequency, then
decrease Control. Adjusting Control to optimal settings may take readjustment.
It is recommended to use the joystick to test the pan and tilt axis. Control the pan
and tilt axis to all angles to see if shaking occurs. It is normal if the pan or tilt axis
shakes one time and doesn’t shake after that.