Zenmuse H20
Series
User Manual
©
2020 DJI All Rights Reserved.
15
Intelligent Functions
Click to Aim
Double-click the point of interest on the main screen, the gimbal will automatically move to the point of
interest in the center of the screen.
High-Res Grid Photo
Drag to select an area in the wide camera view, the gimbal will move automatically and take a series
of 20MP photos of the selected area at the current zoom ratio by the zoom camera.
Tap MENU > Photo Settings, and then select High-Res Grid Photo. After entering this function, the
liveview will switch to the wide camera view. You can set the target shooting area by editing, moving
and zooming the white grid on the screen.
All photos will be saved in the same sub-folder in the microSD card, and an HTML le will be created.
To view the wide and close-up images, open this HTML le using a browser on a PC.
Night Scene
In Night Scene Mode, the camera will switch the IR lter of the zoom camera, which enabled shooting
in low-light environment.
This function is only available for zoom camera, tap MENU > General Settings, and then enable the
Night Scene.
Temperature Measurement*
Spot Meter
The temperature of any position within the temperature measurement area on the screen can be
measured.
Area Measurement
Drag an area within the temperature measurement area on the screen, the average temperature,
lowest temperature, highest temperature, and the corresponding locations of this area will be
displayed in DJI Pilot.
19:29
GPS
12
2.4G
80%
100%
26.1v
26.1v
)39
0(18
10 X
2 X
5.0 X
M
IS
100
utte
1/800
-0.3
1.0X
WIDE
H
222m
H
130.2
ALT
VS
.5
ASL1234.5
63'
1215
=220
1
$(
In Flight (GPS)
To Next Page
Loading...
Need help?
General
