5.3 SYSTEM ADMINISTRATOR
The administrator can perform the following operations from a remote location using a touch-tone
telephone. You must know the phone number of the system and the system master code.
5.3.1 Opening from a Remote Location
1. Call the telephone number that the entry system is installed on. The system will answer
with a short tone (beep).
2. Press * 1 6 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Press the desired tone open number _ (beep). NOTE: Refer to 3.2.6 to determine which
tone open features have been programmed, i.e. momentary open, hold open, release,
hold open one hour and then release.
4. Hang up.
5.3.2 Hold-Open Command
This feature is useful when management wants to open all gates or unlock all doors - perhaps during
an emergency situation as an example.
NOTE: Hold open tone numbers must be programmed for the hold-open command to be
functional. See Section 3.3.3.
1. Call the telephone number that the entry system is installed on. The system will answer
with a short tone (beep).
2. Press * 1 6 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Press the hold open tone number that was programmed in section 3.2.6 _ (beep).
4. Hang up.
5. To release the hold-open command and return the system to normal operation, repeat
steps 1 through 4. In step 3, enter the DEACTIVATE tone number in place of the HOLD
tone number.
45
To Next Page
Loading...
