263LTE-V5 CELLULAR
COMMUNICATOR
Installation Guide
DESCRIPTION
Figure 1: 263LTE-V5
The 263LTE-V5 Cellular
Communicator provides
a fully-supervised alarm
communication path over
the Verizon LTE network. The
263LTE-V5 installs on the panel
inside the enclosure and is
powered by the panel so no
additional enclosure, power
supply, or battery back-up is
needed.
With the 263LTE-V5, Verizon
LTE does not support
MyAccess™ text messaging.
Compatibility
Control panel firmware should be
updated to the following version
when installing a 263LTE-V5:
• XR100/XR500 Series panels
with Version 213 or higher
What is Included?
• 263LTE-V5 Cellular
Communicator
• 383 Antenna
• PCB stando
1
INSTALL THE 263LTE-V5
XR100/XR500 Series Panel
1. Remove all power from the panel.
2. Disconnect the coax cable.
3. Remove the cell card from the 464
interface card.
4. Install the new cell card onto the 464
interface card.
5. Reconnect the coax cable.
6. Remove old antenna.
7. Install the new antenna.
8. Reconnect power.
2
Cellular service is required before you can use the 263LTE-V5 for signal
transmission. The 263LTE-V5 comes ready for activation with SecureCom™
Wireless, LLC. Use the Dealer Admin™ site (DMPDealerAdmin.com), the Tech
APP™, Remote Link™, or call DMP Customer Service (1-866-266-2826) to activate
the 263LTE-V5.
ACTIVATE THE 263LTE-V5
Remote Link Activation
Dealer Admin Activation
1. Navigate to the Dealer Admin site (DMPDealerAdmin.com).
2. Click Customers in the right-side menu and select a customer.
3. Click Add System.
4. Enter a System Name.
5. Select either Cellular or EASYconnect + Cell Backup in the Connection
Type field.
6. Enter the SIM number found on the 263LTE-V5 label and click Get Status.
7. Enter the Account Number.
8. Select a Rate Plan for the 263LTE-V5.
9. Click Activate Cellular Device.
Model 381-2
Coax Cable
from 263
Nut
Washers
Antenna
Connector
18
19
20
21
22 23
24
25
26 27
28
Z5
Z6
Z7
Z8 Z9+
Z9-
Z10+
Z10-
GND
GND
XR100/XR500
Panel
263
Cell Module
464-263
263
Figure 2: 464-263LTE-V5 Wiring
1. Navigate to the Tech APP.
2. Tap Find a Customer then search for a customer.
3. Tap Add a System.
4. Enter a System Name.
5. Scan or enter the Serial #.
6. Select either Cellular or EASYconnect + Cell Backup in the Connection
Type field.
7. Enter the Account Number.
8. Enter the SIM Number found on the 263LTE-V5 label then tap Get SIM
Status.
9. Select a Rate Plan for the 263LTE-V5.
10. Tap Activate Cellular Device.
Tech APP Activation
1. Navigate to Remote Link and select a panel.
2. Select Program in the top menu and select Communications from the
drop-down menu.
3. Select Cellular Network as the Comunication Type and click Activate.
4. Select SIM as the SIM Type.
5. Enter the SIM number found on the 263LTE-V5 label and click Activate.
6. Select a Rate Plan for the 263LTE-V5 and click Activate.
To Next Page
Need help?
General
