DMP Electronics 734N-POE

Need help?

Do you have a question about the DMP Electronics 734N-POE and is the answer not in the manual?

Summary

About the 734 N;734 N-POE

POWER SUPPLY

Details the power requirements and capabilities for the 734N module, including lock control.

Install the 734 N

MOUNT THE DEVICE

WIRE THE ELECTRONIC LOCK

Guides on wiring the Form C relay for controlling locks and barriers.

NETWORK CONNECTION

Explains how to connect the 734N to the network via Ethernet.

WIRE THE ZONE TERMINALS

Covers wiring of zone terminals, including bypass and REX functionality.

CONNECT A CARD READER

Instructions for connecting a card reader and its wiring.

Addressing the 734 N

Keypad Bus Addresses

Explains assigning addresses for XR150/XR550 series panels.

AX-Bus Addresses (XR550 only)

Setting the 734 N Addresses

Provides a chart for mapping device addresses and zone numbers.

Program the 734 N

RESET HEADER

734 N DHCP

734 N IP ADDRESS

Setting a static IP address for the 734N module.

SUBNET MASK

GATEWAY ADDRESS

PANEL IP ADDRESS

Entering the IP address of the control panel.

PANEL IP PORT

734 N PASSPHRASE

Setting an alphanumeric passphrase for encrypted communication.

ACTIVATE ZONE 2 BYPASS

ZONE 2 BYPASS TIME

ACTIVATE ZONE 3 REQUEST TO EXIT

ZONE 3 REX STRIKE TIME

Custom Card Definitions

CARD OPTIONS

Selecting card type (DMP, Custom, Any) for reader configuration.

WIEGAND CODE LENGTH

Defining the total number of bits for Wiegand code.

SITE CODE POSITION AND LENGTH

Configuring site code start position and length.

USER CODE POSITION AND LENGTH

Defining user code start bit position and length.

REQUIRE SITE CODE

SITE CODE

Compliance Listing Specifications

UL ACCESS CONTROL

Specifies configuration for fail-safe/fail-secure access relay.

ULC COMMERCIAL BURGLARY (XR150;XR550 SERIES PANELS)

734 N Network Specifications

Packet Communication

Readers and Credentials

13.56 MHZ SMARTCARD READERS*