Need help?Do you have a question about the DMP Electronics 734N and is the answer not in the manual?
General| Brand | DMP Electronics |
|---|---|
| Model | 734N |
| Category | Control Unit |
| Language | English |
Details wiring the Form C relay for controlling electronic locks and barriers, including power limits.
Explains connecting an IP network cable and the function of the Ethernet jack LEDs.
Explains zone terminal wiring and the use of End-of-Line resistors.
Provides a chart for mapping device addresses and 734N zone numbers for keypad and AX-Bus configurations.
Instructions for resetting the module by shorting the reset header pins before or during operation.
Configure DHCP for dynamic IP or enter static IP, Subnet Mask, and Gateway Address.
Sets the IP address of the control panel for module communication.
Sets the panel IP port for communication and an encryption passphrase.
Enables or disables the zone 2 bypass operation for entry/exit timing.
Sets the duration in seconds for the zone 2 bypass entry/exit timer.
Enables the Request to Exit (REX) functionality for zone 3.
Sets the duration in seconds for the REX strike activation on zone 3.
Configures card reading modes (DMP, CUSTOM, ANY) for reader activation.
Specifies the total number of bits in the Wiegand code, including parity.
Defines the starting position and length for the site code in the data string.
Sets the start position and length for the user code within the data string.
Allows programming up to eight three-digit site codes.
Details network impact, supervision, security features, and AES encryption.
To Next Page
