Digital Monitoring Products, Inc. | 734N Installation and Programming Guide 1
ANNUNCIATORS
An on-board programmable piezo provides local
annunciation at the 734N. You can also connect
a variety of switched ground annunciators to the
734N for remote annunciation.
INDICATOR LEDS
The 734N provides three indicator LEDs. The
red LED turns on for the same duration as the
door strike relay. The yellow LED turns on for one
second to indicate receipt of a valid Wiegand
input. The green LED indicates that data is being
sent to the panel.
The 734N and 734N-POE Wiegand Interface Modules allows you to add IP network access control
capability to XR150/XR550 and XR150INT/XR550INT Series panels using proximity credential or
mag-stripe card readers. The modules also allow you to use the powerful built-in access control
capability of DMP Panels.
POWER SUPPLY
The 734N operates at 12/24 VDC from the power
supply supporting a door’s magnetic lock or
door-strike. It can also be powered from POE.
The 734N provides a 10 Amp Form C relay
contact for lock control.
ZONE TERMINALS
Four input zones are provided to allow
connection of nearby burglary devices.
ABOUT THE 734N/734N-POE
To Next Page
Loading...
Need help?
General
