0317 © 2005 Digital Monitoring
SEC LANG: NONE
The current secondary user language is displayed. Selecting a secondary user
language allows the user to view the User Menu and Status List text in English
or Spanish. When the User Menu is accessed, the user is prompted to choose
the display language. Status List text displays in the selected language until
another language is chosen. If SEC LANG: is set to NONE, the option to choose
a language does not display. To select a secondary language, press the Select
key below the language. Default is NONE.
For example, when Spanish is selected at a keypad, the User Menu and Status
List text display in Spanish at that keypad. When the user later accesses the
keypad, pressing the COMMAND key once displays the option for English or
Spanish. Pressing the COMMAND key again continues to display the Status List
text in Spanish. Later on, if English is selected at that keypad, the User Menu
and Status List text display in English at that keypad.
NONE ENG SPN
Select the secondary user language.
NONE = No secondary language options are displayed
ENG = English
SPN = Spanish
Arm First Option
The XR500 Series panel now provides the option in Area Information to program an area to
automatically arm when any other area is armed from a keypad.
ARM FIRST NO YES
Arm First Area
Select YES to enable this area to operate as an Arm First area. This area is
automatically armed when any non-Arm First area assigned to the same
keypad is armed but does not disarm when other areas become disarmed.
Assign areas to keypads using the Display Areas option in Device Setup
programming. You can have multiple Arm First areas in a system and divide
them among keypads if needed. If an Arm First area has faulted zones that
cannot be bypassed, arming stops and the areas are not armed. Correct the
problem with the Arm First area and then begin the arming process again.
Default value is NO.
Note: The Arm First automatic arming only occurs when arming from a
keypad. Arming from a zone, schedule, or remotely is not affected and Arm
First areas do not automatically arm.
User Codes
The XR500 Series panel now allows six-digits to be programmed for user codes. These six-digit user
codes can be used when manually entered at a keypad or entered from a card reader attached to a 734
Access Control Module. User Codes entered by the user from card readers attached to keypads and the
733 Access Control Module continue to accept a maximum five-digit codes only.
To Next Page
Loading...
Need help?
General
