(No.HD003<Rev.004>)1-39
[NEXT]
>>Sensor
0010010001100100
>>>ADPORT0
>>>ADPORT1
[ENTER]
[EXIT]
[ ]
[NEXT]
>>>Retransfer
>>>Bend Remedy
[ENTER]
[EXIT]
[NEXT]
>>>Retransfer
>>>Bend Remedy
[ENTER]
[EXIT]
[NEXT]
>>Table Ver
>>Thermal Head
>>Assistance
>>HR POT>
[NEXT]
[NEXT]
[NEXT]
[NEXT]
>>HR POT Reset>
[NEXT]
>>Memory
>>Display
>>Back Color
>>Register>
>>Firmware Ver
>>Config Ver
[ENTER]
[EXIT]
[NEXT]
>Information>
[NEXT]
[NEXT]
[NEXT]
[NEXT]
33
4
>Push
>Pop
[NEXT]
[NEXT]
>Error Log Clear
[NEXT]
Display for 1 sec Display for 1 sec
In case of an error, the buzzer sounds and the LED lights.
When there is no error, the indication just returns to the initial indication.
Display for 1 sec Display for 1 sec Display for 1 sec
Value obtained by A/D conversion of
the thermistor value of the heater or head.
Firmware version
Configure version
Table version
Information of Thermal Head
Cleared the total lighting time of the heat roller
Parameter settings save in the head EEP-ROM.
* The buzzer beeps in case of an error.
Loading the parameter settings from the head EEP-ROM.
* If the correct data is not stored by the head EEP-ROM,
"No Data" is displayed and the buzzer beeps.
Cleared the error log
To Next Page
Loading...
