Mute (Or Unmute) Microphone During Call
• During a call, push the “Voice Command” button .
• After the BEEP, say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, push the “Voice Command” button .
• After the BEEP, say “transfer call”.
Changing The Volume
• Start a dialogue by pushing the “Phone” button , then adjust the volume during
a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Uconnect system is speaking. Please note the volume setting for Uconnect is
different than the audio system.
Uconnect Voice Command
The Uconnect V oice Command system allows you to control your AM, FM radio, satellite
radio, disc player, Uconnect Phone and supported portable media devices.
When you push the “V oice Command” button
located on the steering wheel, you
will hear a beep. The beep is your signal to give a command. If you do not say a command
within a few seconds, the system will present you with a list of options. If you ever wish to
interrupt the system while it lists options, push the “Voice Command” button
,
listen for the BEEP, and say your command.
Voice Command Operation
Start a dialogue by pushing the “V oice Command” button , you will hear a beep.
The beep is your signal to give a command. Below are a list of voice commands for each
of the different modes.
ELECTRONICS
65
To Next Page
Loading...
Need help?
General
